top
logo

CARVIN BASSES

Login Form




The Strip - complete channel strip
Products - Produits - TK Audio products - Produits TK Audio

The Strip

The Strip (ST1) is a complete and easy to use channel strip with a mic preamp, compressor and EQ - a perfect tool for the recording engineer, songwriter or producer on the go that needs a great sounding recording channel. The preamp is a transformerless design with up to 75 dB of ultra-clean amplification; enough to power low output ribbon and dynamic microphones. The high-impedance instrument input on the front is perfect for instruments like synthesizers; acoustic, electric and bass guitar.

The switchable high-pass filter removes unwanted low-frequency energy below 80 Hz.

The compressor uses RMS detection without timing controls which makes it easy to use for a lot of different instruments like vocals, bass, acoustic guitar and more. The depth and character of the compression is set with the Threshold and Ratio parameters. Parallel compression can be done by adjusting the blend of dry and compressed signal. There is a 10 LED meter showing the gain-reduction with a dot or the preamp headroom with a bar.

The EQ is a classic Baxandall design with two smooth-sounding shelving filters; the 100 Hz low-shelf filter is ideal for removing excessive bass energy or adding weight to the low-end; and the 12 kHz high-shelving filter perfect for adding some air. Both filters outperform their digital equivalents (plug-ins) by sounding smoother and more analogue.

Finally ST1 has two different output stages, an electronically balanced output stage or a discrete transformer-balanced class-A stage, built around a heavy Carnhill output transformer. The vintage class-A mode produces a fat and punchy sound with mid range character and a warm top-end. The IC-based output stage is less colored and ideal for clean amplification.

The Strip makes a perfect companion in almost any recording situation producing a musical smooth and detailed sound.

Key Features:

Up to 75dB of ultra-clean gain
Easy to use RMS compressor
Blend control for parallel compression
Shelving filters at 100Hz and 12kHz
Vintage class-A mode selectable
Carnhill output transformer
Hi-Z input on the frontSpecifications:

Features:
Hi-Z input:  instrument input with more than 1Mohm input impedance.
48v phantom power.
Gain: 20dB to 75 dB gain.
Pad -30dB
Gainreduction/Headroom meter select.
HPF: 80Hz/12dB filter.
Threshold: -20dB to +15dB.
Ratio: 1.5:1 to 20:1.
Make-up: 0dB to 20dB
Blend control: From dry to wet.
Compressor in/out.
EQ in/out.
Low: 100Hz +/-12dB, shelving
High: 12kHz +/-12dB, shelving
Vintage transformerbalanced class-A or a electronic balanced outputstage. 
Output level.
Phase-reverse switch.

 

bottom

Animé par Joomla!. Designed by: Free Joomla 1.5 Template, what is anti virus. Valid XHTML and CSS.